How it works

No drill, no damage — done in minutes

Every Klebr accessory mounts with a strong self-adhesive backing. No tools, no holes, no mess.

1. Peel

Peel the backing film off the pre-applied adhesive pads.

2. Press

Press firmly onto a clean, dry surface — tile, glass or sealed stone — for 30 seconds.

3. Done

Wait about an hour for the bond to set, then load it up.

Which surfaces work?

Klebr sticks to smooth, sealed surfaces such as tile, glass and sealed stone. Avoid raw concrete, wallpaper and textured or peeling paint.

Removing it later

Warm the adhesive with a hair dryer, gently lift the product, and peel the strips away. Wipe any residue with a little isopropanol. Fresh adhesive strips are needed to remount.